Size Guide

Start with the measurements and size options shown on each product page. Fit can vary by design and by how you prefer to wear a piece, so there isn't one size chart that works for everything.

Rings

If you already have a ring that fits the same finger, measure its inside diameter and compare it with the measurements listed for the piece you're considering.

Check whether the product uses diameter, circumference or another sizing system, and keep these measurements separate. If a measurement or conversion you need isn't listed, contact us before choosing your size.

Necklaces & Pendants

Check the listed necklace length and any extension separately. It can help to compare these measurements with a necklace you already wear and like.

If you're choosing a pendant, check the product page to see whether a chain is included. Where a necklace sits will vary with the design and the wearer.

Bracelets & Rigid Bangles

First check whether the listed measurement refers to bracelet length, circumference or inner diameter.

For a closed rigid bangle, remember that it also needs to pass over your hand. Wrist circumference alone cannot determine whether a rigid bangle will fit, so comparing it with a bangle you already wear is the most useful reference.

Avoid applying one fixed wrist-plus-length rule to every bracelet, as fit varies by design.

How to measure your wrist

Wrap a soft measuring tape around your wrist where you would normally wear your bracelet. Keep it snug without pulling it tight, and note the measurement in centimetres. If you do not have a measuring tape, use a strip of paper or string, mark where the ends meet, then measure it against a ruler. Measure your wrist rather than an existing bracelet. For made-to-order bracelets, choose the wrist measurement closest to yours from the available sizes. If you are between sizes or unsure about the fit, WhatsApp us before ordering.

NEED HELP?

For help with a particular piece, email support@anses-and-co.com with the product name or link.